Delivers 4 avg scfm @ 90 psi Delivers 4 avg scfm @ 90 psi for medium duty pneumatic tools Crankcase design is up to 25 percent larger than competitive models for improved performance and less oil carryover Cast iron oil-lubricated pump for long lasting, reliable performance 4-gallontwin stack tank design for portability
found in HL5502's description:From the Manufacturer
Even for occasional home maintenance, air tools are more practical and less costly than expensive electric power tools with umpteen mechanical parts and exorbitantly priced batteries of all shapes and sizes. But before investing in smart air tools, you need a quality compressor. This popular 4-gallontwin stack aircompressor from Campbell Hausfeld is oil lubricated and built to last. Ideal for inflation, nailing, stapling and spraying jobs, this compressor also powers everything from sandblasters and spray guns to drills and die grinders in a matter of seconds. So, rather than investing in an expensive new electric tool set; save time and money with this 4-galloncompressor and Campbell Hausfeld's line of 70 high quality air tools. The initial cost of an air tool is significantly lower than its electrically powered counterpart, and the average tool life expectancy is longer, too. Plus, when powered by this 4-galloncompressor, air tools deliver more torque and higher revolutions-per-minute than electric tools for less downtime and greater productivity.
FEATURES
4-gallontwin stack tank design for portability
Cast iron oil-lubricated pump for long lasting, reliable performance
Crankcase design is up to 25 percent larger than competitive models for improved performance and less oil carryover
Delivers 4 avg scfm @ 90 psi for medium duty pneumatic tools
SPECIFICATIONS
Output: 4 avg scfm @ 90 psi
Type: oil-lubricated
Capacity: 4-gallon
.
found in HL5502's reviews: The facts about this aircompressor - Don't believe everything that the editors at Amazon wrote about this compressor. With those jobs you need a large tank capacity like over 20 gallons at least, this compressor only has 4 gallons. Yes it is true what the other reviewer said, this compressor is loud, but what do you expect all aircompressors are relatively loud. And yes this compressor is heavy I think it's about 70 lbs. Hitatchi's twinstack oil-lube version is about the same as this compressor but goes for twice the price. Other than that I think that this compressor is a buy because it's oil-lubed (more reliable than oil less), affordable, and made by a company that is known for it's aircompressors.
Protected components for maximum durability Oil lubricated pump allows for long life Low oil shut off provides greater engine protection Automatic idle control for reduced fuel consumption 4 HP Honda GX gas engine provides proven reliability and durability
found in D55250's description:Product Description
4 HP, 4 Gallon, Gas Twin Stack Compressor, High Volume Air Output 4.5 CFM @ 100 PSI, Portable Air Power Honda 4 HP Gas, Automatic Throttle Idle Control, Direct Drive Pump For Improved Portability, Oil Lubricated Improved Compressor Life.
12-Month limited warranty Electric direct drive and oil splash lubricated for longer life Contractor grade, heavy duty pump with cast-iron cylinder Industrial grade motor with ball bearings provides greater durability 4.3 gallon capacity twintanks, 2.5 HP (peak)
found in GR254CTS's description: These same principles are now built into Grip-Rite's line of professional quality tools and compressors. Make no mistake, this compact but rugged compressor will keep the busiest roofing and framing crews going all day, job after job. The pump is cast iron and it feeds into twin stack tanks holding an ample 4.3 gallons. The design of this unit was intended to minimize the footprint while still offering enough air to handle almost any job.3 gallontank, 56 lbs total weight, 74 seconds pump up, 23 second recovery and 125 max psi, 14. Compare to: Hitachi EC119, Porter Cable Job-boss Model #C3551, Porter-Cable CPLDC2541S, Porter-Cable CPLDC2540S, Rol-Air The Bull.
4-gallontwinstack tank Dual quick connects on control panel Easy to use control panel Oil-free pump for low maintenance and easy operation High out-put motor for high performance
found in EX8000's description:From the Manufacturer
This compressor is ideal for job site work. It produces air flow needed to operate multiple nailers. The twinstack tank design is easy to carry around the work site.
18-1/2 by 15 by 16-3/4 inches; 60 pounds; 1-year warranty Includes DEWALT synthetic compressor oil and pressure regulator Cylinder constructed of cast iron Delivers 3.2 cfm at 100 psi; features overload protection to eliminate risk of motor damage 14 amp 2-1/2-horsepower 4-gallon oiled twin hot dog compressor with carrying handle
found in D55151's description:From the Manufacturer
This versatile compressor can perform a multitude of jobs, from roofing to finish to trim to home/hobby applications. The compressor delivers 3. Includes 3/8-inch regulator and initial fill of DeWalt synthetic aircompressor oil.2 cubic feet per minute delivered at 100 psi, enables speedy recovery
Oil-lubricated pump improves durability
4-gallontwin-stack tank design offers proven acceptance in the market
Lightweight design improves portability
Overload protection eliminates risk of motor damage
Dual soft-start valves assist in cold weather startup
Cast-iron cylinder enhances pump life
Specifications
Drive: direct drive
Horsepower: 2-1/2 max hp
Tank size: 4 gallons
Power supply: 120-volt AC, 14 amps, 60 Hz, 2-pole induction motor
Cubic feet per minute at 100 psi: 3.
Includes
DeWalt synthetic compressor oil
Pressure regulator
Warranty This DeWalt high-performance industrial tool comes with a warranty package that includes: 30-day, no-risk satisfaction guarantee One-year free service contract One-year warranty
Product Description
Portable electric powered compressor with 2 HP, high output motor. 4 gallontwin stack tank design. ASME approved tank and CSA certified.
5.1CFM @40 and 4.0CFM @90 Synthetic pump oil for low temp operation Dual air outlets Cast iron pump cylinder for extreme durability 3 peak HP 15 amp induction motor
found in CWC200ST's description:From the Manufacturer
3HP Oil Lube Stack TankCompressor.
Product Description
Portable, electric powered compressor with 3 HP, high output, heavy-duty induction motor. Dual stacked cast iron tank design with 4.5 gallon capacity (two 2.25 gallontanks).
found in CWC200ST's reviews: Compressor head is OK but the extra parts are of low quality - I bought one of these compressors a couple of months ago after doing carefull research and actually going to a repair facility here in AZ that handles warranty repairs for a variety of brands. I estimate that the compressor has about 15 (fifteen) hours of use by now. The condensation drains are installed in a bad place and when open do not drain because they are too high on the tanks I estimate that it will have over a QUART of water inside each tank before any will reach the drains. You will have to tilt the compressor down and rock it side to side to get the water out, furthermore when tilted the lower drain hits the floor impedig drainage so you actually have to lift this rather heavy machine and tilt it and rockit at the same time in order to drain. Shortly after purchasing the unit one of the Quick Disconnects on the compressor will not seal itself after the hose is taken off and will merily leak all the air out in about one minute, I had to replace that so I could use the machine. For about the last five hours of use I started to notice that if left pressurized overnight the air was gone in the morning upon closer inspection I could hear a faint hiss comming from somewhere behind the regulator It was not much just enough to leak and turn the machine on about every 15 minutes even if I did not use air. Yesterday the manual regulator prooved to be the culprit as when I started the compressor for the first time it would not hold air at all. I put my head next to it to listen for the noise of air escaping and sure enough there was a faint hisssss. While I was trying to figure out where the noise is caming from The back of the manual regulator popped loose again suddenly letting all the air escape in an instant startling me and prompting my wife to ask from the kitchen some ways away: "did you do that on purpose?" Well NO. Overall the tech was right the actuall compressor is well done I believe he said it was Italian made the rest is rather sloppy and not thought out well.
60 gallon vertical tank is a space saving design with easy access to tank tray 6.5 HP Peak motor provides significant power for tough jobs Unique product design from the largest manufacturer of reliable and durable, single stage CAST IRON pumps in the USA Oil-Lubricated pump has a traditional design that is quieter and longer lasting than oilless pumps Solid Cast Iron twin cylinder pump provides up to 5,000 hours of extended life. Over 35% quieter and 60 degrees cooler than aluminum pumps with cast iron cylinder sleeves.
found in VT6275's description:From the Manufacturer
The VT6275, 60 gallon oil-lubricated aircompressor has a solid cast iron twin cylinder pump that provides up to 5,000 hours of extended life.
Product Description
mfr: Campbell Hausfeld Air Products Campbell Hausfeld is a recognized leader in the home improvement and automotive industry.
SINGLE STAGE AIRCOMPRESSOR. Single Stage Cast Iron Compressor7 HP Peak, 60 Gallon Vertical, 240 Volt.
found in VT6275's reviews: Great Quality at a Great Price - I needed to upgrade my shop aircompressor and had narrowed my choices to Ingersoll Rand and Campbell Hausfeld.com sells aircompressors and had an incredible deal on the Campbell Hausfeld VT6275 60 Gallon. Great quality compressor at a great price and a very smooth transaction.
Ball valve drain allows for quick and thorough tank draining Dual voltage feature allows easy switching from 120 to 240 volts Dual control feature allows start/stop or constant run option Twin cylinder, cast iron, oil lubricated pump 8.4 cfm delivered at 100 psi with 17-gallontank
found in D55585's description:From the Manufacturer
You will never run short of air again with this 2-horsepower electric wheeled compressor supported by an ASME-coded 17-gallon OSHA-recognized tank. The twin-cylinder, cast-iron, oil-lubricated pump is backed by Emglo's 50 years of proven durability and reliability. The user can quickly and completely drain the compressor by the ball valve drain, which won't clog like other models that use needle valves. The D55585 includes DeWalt's synthetic compressor oil and a 3/8-inch NPT pressure regulator.4 cubic feet per minute delivered at 100 psi, enables speedy recovery
Twin-cylinder, cast-iron, oil-lubricated pump with Emglo's 50 years of proven durability and reliability
2-horsepower motor provides increased performance
Dual wheels make maneuvering easier on the worksite
Dual control feature allows start/stop or constant run operation
Dual voltage feature allows easy switching from 120- to 240-volt operation
ASME-coded 17-gallon OSHA-recognized tank
Ball valve drain allows for quick and thorough tank draining
Specifications
Drive: belt drive
Horsepower: 2 hp
Tank size: 17 gallons
Power supply: 2-pole induction motor
Cubic feet per minute at 100 psi: 8.
Includes
DeWalt synthetic compressor oil
3/8-inch NPT pressure regulator
Warranty This DeWalt high-performance industrial tool comes with a warranty package that includes: 30-day, no-risk satisfaction guarantee One-year free service contract One-year warranty.
30 day satisfaction guarantee and one year warranty on parts and labor Twin drain locks Cast iron pump Twin 4 gallontanks 5.5 hp Honda engine
found in EC25E's description:From the Manufacturer
The EC25E is a commercial grade gas drive compressor from Hitachi. The 10-inch fly wheel includes a baffle to direct cool air towards the pump.
Product Description
Hitachi EC25E is a commercial-grade gas-driven compressor from Hitachi. The pump and crankcase feature oil-splash lubrication and a ball-bearing-mounted crankshaft, ensuring the compressor will be running for years to come. The unit's twin draincocks, one of each of the 4-gallonairtanks, makes it easy to purge the tanks of compressed air and condensation, helping prevent internal corrosion. In addition, the EC25E's large canister intake filter keeps the air running through the compressor and your nailer clean. The 10-inch flywheel includes a baffle to direct cool air towards the pump.