MPT and FPT Quick Connect Coupling; MPT and FPT Quick Connect Plug; Tire Inflator Chuck; Thread Sealant Tape 3/8" x 25' Coil Hose with fittings, blow gun, Inflation nozzle, Tire Inflator, Tire pressure gauge, Quick connect fittings, and sealant tape
CAP2560OL 2.5HP (Peak) oil-lubricated contractor compressor N80 Stick Framing Nailer
found in U-CPACKN80's reviews: Poor shipping procedures--TWICE! - I ordered this compressor and framing nailer for a shop I was building. I chose the free shipping because I had about 10 days before I was to begin construction. It was ~$50 so I opted to stay with the free shipping. Finally the box arrived-late-I had to borrow some air tools. The compressor had no oil in it. It had obviously been turned on it's side and it leaked out over everything-compressor and nailgun. I found it lying on it's side, wet with oil again. Bostich was generous enough to send new gauges free of charge. I installed them, replaced the oil and plugged it in only to get a motor hum that quickly kicked off the breaker. The airgun I borrowed was a Bostich, and it worked extremely well.
Dual voltage feature allows easy switching from 120- to 240-volt operation Dual control feature allows start/stop or constant run operation Low profile design for easy maneuverability Twin cylinder, cast iron, oil lubricated pump 6.5 cfm @ 100 psi for quick recovery
found in D55570's reviews: Nice Unit - This aircompressor, like most DeWalt tools is a great piece of equipment.
The compressor will run smoother on start/stop operation if ran on 220V. Also, it's hard to beat the free super saver shipping (allow 18 days to Washington)and 10% discount that Amazon is currently promoting.
I'm very pleased with the DeWalt D55570 compressor and Amazon's service.
60 gallon vertical tank is a space saving design with easy access to tank tray 6.5 HP Peak motor provides significant power for tough jobs Unique product design from the largest manufacturer of reliable and durable, single stage CAST IRON pumps in the USA Oil-Lubricated pump has a traditional design that is quieter and longer lasting than oilless pumps Solid Cast Iron twin cylinder pump provides up to 5,000 hours of extended life. Over 35% quieter and 60 degrees cooler than aluminum pumps with cast iron cylinder sleeves.
found in VT6275's description:From the Manufacturer
The VT6275, 60 gallon oil-lubricated aircompressor has a solid cast iron twin cylinder pump that provides up to 5,000 hours of extended life.
Product Description
mfr: Campbell Hausfeld Air Products Campbell Hausfeld is a recognized leader in the home improvement and automotive industry.
SINGLE STAGE AIRCOMPRESSOR. Single Stage Cast Iron Compressor7 HP Peak, 60 Gallon Vertical, 240 Volt.
found in VT6275's reviews: Great Quality at a Great Price - I needed to upgrade my shop aircompressor and had narrowed my choices to Ingersoll Rand and Campbell Hausfeld.com sells aircompressors and had an incredible deal on the Campbell Hausfeld VT6275 60 Gallon. The deal included free shipping; this was true free shipping all the way into my shop. Great quality compressor at a great price and a very smooth transaction.
Three year limited warranty Cast-iron cylinder and stainless steel valves for cooler operation
Patent pending oil-lube system with ball bearing design
Direct drive, no belts or adjustments are necessary
2.5 horse power, 4-gallon oil-lube compressor
found in CPLDC2540P's reviews: Design flaws - First one of these I received came out of the box damaged beyond repair. Switch was broke, regulator fitting broken off flush with the tank, tabs on the compressor that the shroud connects to were broken off from the compressor. After about 2 hours of use (with me that translates to about 3 months) one of the tabs on the compressor that connects to the shroud has broken off. I have not moved the compressor since the day I took it from its box. It's a bit loud but not as loud as some of the "oilfree" compressors are.
Low amp draw at 14.0 Lightweight and power-packed at just 40 lbs. Pump-up time 55 seconds, recovery time 85 seconds 2.5 hp, 2-gallon tank
found in PC2061's reviews: Very Nice little compressor - This is a great little compressor from Senco's discontinued line of Accuset tools .
I like this compressor because of its relatively light weight [39 pds. Most of the bits that would tend to get knocked off during loadind and moving are enclosed in the plastic shrouding around the motor , and the air chuck is sensibly and securly mounted on top so pulling by the air hose shouldn't break it off as has happened with other compressors I've owned . Keeping in mind that it is oil less [which means they use teflon coated rings in stead of an oil bath] I would say it falls in the middle or slightly below for a decible rating of compressors of this type . Only the Thomas industries line of compressors could truly be called quiet from what I've seen.
As for qaulity and performance , I had to replace 4 rooms of carpeting about 9 years ago due to a "leak free" oil bath compressor so I switched to these oiless types and have found them to be flawless and I've never looked back. Obviously you wouldn't run a large framing crew with it , then you'd have a gas powered compressor. It still uses a 3450 rpm motor to get the air output/low 14 amp draw . Other machines sometimes have 1750 rpm motors which are quieter but pump less air.
One Year Warranty Supports use of all brad and finish nailers and moderate use of framing and roofing nailers High-flow regulator allows more work at higher pressures 3 hp induction motor for quieter operation High-pressure technology provides more usable air for longer run time
found in CPF23400P's reviews: good unit for the price - So far it has been trouble free. although i do take my large compressor i find the unit that usually comes out of the truck is this one.BUT IT'S A COMPRESSOR. if you have a need for a lightweight fairly high SCFM unit, this might fit the bill. Great Little Air Squeezer!!! - This little Porter Cable compressor is all (and more) that I expected it to be. The output should be more than adequate for my needs to run an air ratchet, blow nozzle, hand sandblaster and pressurize a small auxilliary portable tank. Works like a champ, the price was right and Amazon's Free SuperSaver Shipping made this a no-brainer bargain. A good compressor to get you started. - I shopped extensively for a light duty compressor based on the following criteria: price, weight, and flow rating. It features the same motor and compressor as the PC 3HP twin stack model but is $40 cheaper and about 10 pounds lighter. It is an oilfree design, so it can operate on uneven ground. The oil splash designs are supposed to have greater durability but for my infrequent use it should be just fine.
Other than that what can I say - it pumps air. It is fairly loud, but I haven't listened to many other models to make an educated comparison. I have used it quite a bit for high air flow operations, such as blowing off dust / debris and even running an air chisel to bust up concrete. It often runs full time for 5-10 minutes and is able to keep up with air demand. If you are going to be regularly moving the compressor around, spend the extra. I actually ran a compressed air line out to my garage, so the compressor can stay put in the basement and avoid potential damage from moving it.
*** 4-year update ***
I have owned this compressor for 4+ years now and am still completely satisfied. I used a hand held, air chisel to break up the mortar joints. The compressor was operating at 100% duty cycle for 10-15 minutes at a stretch, but couldn't quite keep up with continuous use of the air chisel. As an last ditch experiment, I bought a 10 gal portable air storage tank, some extra quick disconnect fittings and rigged up a reserve tank in parallel with the 4 gallon PC tank. (yes, I am an engineer) My thinking was that I would run the crap out of my little PC and if it bit the dust, that was my excuse to buy a new compressor. I am amazed to say the PC compressor ran flawlessly for the entire chimney demo and still works fine today.
One-year warranty Rugged cast-iron cylinder Performs at above average working pressures Delivers 3.6 cfm at 125 psi Powerful 2 hp electric motor
found in AM780-HC4V's reviews: CONTRACTOR COMPRESSER DREAM - DOWN TIME ZIP DAY IN AND OUT YEAR AFTER YEAR ENOUGH AIR TO RUN TWO FRAMERS AT A GOOD RATE OF PACE . THIS IS A TROUBLE FREE LIGHT WEIGHT COMPRESSER THAT WON'T HURT YOUR BACK HAULING IT IN AND OUT OF THE TRUCK DAY AFTER DAY FOR YEARS . Great But ... - I have several compressors, but since this is light and runs on 15 am circuits it is the preference for small volume needs such as small nail guns, tires and especially jobs where transporting the compressor is required. Example, a framer and helper will easily outrun the production capability of the compressor with one gun. On a hot day with poor air circulation the motor start capacitor blew. Since this was the only issue with the tool I decided it made sense to repair. My standard motor repair shop wouldn't touch it. The Emglo repair center wanted an exhorbitant amount for the capacitor ($$). The time I spent calling around and shopping for the replacement part far exceeded the value of simply replacing the compressor unit. The advantages of convenience, weight and maintenance free performance come at a price.
One Year Warranty Convenient control panel has regulator, gauge, and two quick connect outlets Higher tank pressure provides more usable air per tank re-charge New high-pressure design keeps tank pressure between 110 and 135 PSI 3 HP induction motor delivers 7.7 SCFM at 40 PSI, 5.5 SCFM at 90 PSI
found in CPF23400S's reviews: look no more - 175 bucks and free shipping, no brainer, buy 2 because your neighbor won't return yours when you lend it to him. Exceeds My Expectations - I had a Porter Cable pancake compressor and was happy with it for around the house projects and use. It was stolen (smart thief) and I replaced it with this compressor. I ordered from Amazon, paid about $80 less than the local stores, paid no tax, shipping was free, and delivery was ahead of schedule and it arrived in perfect condition. This compressor is also quieter than the pancake compressor I had. First Impressions... - It only took 3-days for my new compressor to arrive at my doorstep! And best of all, the shipping was free! I immediately unpacked the unit and checked it over. Although I haven't used my compressor yet, first impressions are everything. This unit is compact, relatively light weight, fairly quiet, and fills up extremely quick! I can't wait to attach my air nailer and get to work!!!. Darn Good Little Compressor - Short and sweet - this compressor delivers on its promises - it is easy to use, easy to break-in, easy to maintain, and you can't beat the duel air hose inlets. I have found both of the built in pressure gauges to be accurate, and the oil-free motor is quieter than other compressors I have used (although it still makes a good bit of noise). To me, that's portable - I can understand how that would not be the case with everyone, but my experience leads me to believe that this compressor has a very good weight-to-horsepower-to-air storage capacity ratio. This Portable Compressor is Rugged and Well Built ! - Surprised and impressed! I looked at Home Depot and Lowes and decided to order this aircompressor to save the Tax and the trouble of bring it home.
SHIPPING WAS FREE, THAT SEALED MY DECISION TO BUY.
Looking at the other brands of portable compressors I really like how well this one is built. Heavy Duty versatility - First off I am a homeowner, not a contractor and have been using this compressor in my house to do renovation trim work for over two years. It is a fantastic compressor for my purposes. I run one in to my garage for airing my tires, and one in the shop for projects. When I move the compressor in to a room I am renovating, the two outlets also let me have two tools going at the same time, i. I will tell you it is LOUD but so are all compressors in this class, and this one is not as loud as my last old Campbell-Hausfeld. So if you are planning on moving your compressor around a lot, this is the WRONG compressor for you. But if you want a relatively stationary compressor with greater than ordinary capabilities, you may agree this is the ticket. It has run glitch free and recharge time is fast. Don't know yet - I spoke with the owner of the company, Kim Allen, and he said that I would need to have it repaired under the warranty. After several calls to the toll-free number in the manual to the factory, I was put in touch with a repair facility an hour away and was told they don't stock the part but could order it and get it back to me in a few days. Hopefully, PC will come though without me spending four round trip hours and a week without a compressor.
One-year warranty Provides 8.6 SCFM at 40 PSI and 6.8 SCFM at 90 PSI High-flow regulator for more efficient operation of pneumatic tools Tank pressure is maintained between 110 and 135 PSI for more usable air High-pressure technology provides the equivalent of a 32-gallon air supply
found in CPL6025's reviews: WARNING - Amazon's "free" shipping SUCKS! - So, they offer "free shipping", not "free delivery.
2-gallon tank adds greater stored air capacity Up to 50% quieter than competitive models for a more comfortable work environment On-board accessory storage keeps small accessories organized and readily available Hose management system keeps hose coiled when not in use for easy transportation and compact storage Using the included hardware, the compressor can be wall-mounted freeing up valuable work space
found in FP205299AV's reviews: A great value - It won't spray paint a house or car, but has enough volume to do touch up jobs with a light duty air brush type spray gun. It will power some air drive tools as well, stapler, etc. I paid even less than the Amazon price, but the Amazon price is the best on the web when it includes free shipping.